Q690钢焊接接头微观组织对冷裂纹的影响研究

分析了Q690钢手工电弧焊与气体保护焊焊接冷裂纹产生与微观组织的联系。结果表明: 焊接冷裂纹起源于斜Y坡口根部, 沿熔合区、焊缝扩展至焊缝表面;2种工艺焊接的接头组织硬度均较母材高, 而塑性较差。热影响区为马氏体、贝氏体与铁素体混合组织, 焊缝组织由先共析铁素体、侧板条铁素体、贝氏体和针状铁素体等组成, 针状铁素体抗裂纹扩展能力较其他组织强。在2种焊接方法对应断口中观察到了冷裂纹起裂、扩展与断裂区的不同形貌, 起裂与扩展区存在塑性变形, 而断裂区为解理断裂。     

An image encryption scheme based on precision limited chaotic system

Multimedia Tools and Applications - In recent years, various chaotic maps have been used for image encryption. However, most of these image encryption algorithms entail a lot of floating-point...     

含煤盆地深层“超饱和”煤层气形成条件

中国深层煤层气资源丰富，但总体勘探和认识程度较低，尚未形成较为系统的深层煤层气地质理论。通过解剖分析准噶尔盆地白家海凸起和鄂尔多斯盆地临兴区块深层"超饱和"煤层气井的试气/生产动态，估算原地游离气的含气量，分析了深层"超饱和"煤层气的形成条件。研究表明：①深层"超饱和"煤层气储层中除吸附气外，还含有原地游离气，用常规试气方法可直接获得气流，煤层气的产出不明显依赖于排水降压；②埋藏超过一定深度，在煤阶和温度的综合作用下，煤的吸附能力将随埋深的继续增加而降低，煤层中吸附气的饱和度有增加的趋势，在达到吸附饱和后，出现原地游离气并形成"超饱和"煤层气，盆地深层具有"超饱和"煤层气形成的优势条件；③由于地温梯度和压力梯度的不同，不同盆地"超饱和"煤层气出现的临界深度不同，异常高压和异常高热流可以降低深层"超饱和"煤层气形成的临界深度；④深层"超饱和"煤层气开发具有大大缩短见气时间、充分利用地层能量和累积产水量低等优势，有望成为未来煤层气勘探开发的一个重要领域。     

Formation of a protective layer against corrosion on Mg alloy via alkali pretreatment followed by vanillic acid treatment

Although Mg alloy possesses high specific strength, low density, and good biocompatibility, poor corrosion resistance hinders its further applications. In the present study, an innovative protective layer against corrosion was prepared on the AZ31 Mg alloy via alkali pretreatment followed by vanillic acid treatment. The alkali pretreatment supplied –OH for the AZ31 Mg alloy surface to react with vanillic acid. The vanillic acid treatment played a crucial role in enhancing the corrosion resistance due to the excellent ability to act as a barrier and retard aqueous solution penetration, which effectively isolated the underlying Mg alloy from the corrosive environment. The corrosion current density of alkali and vanillic acid-treated Mg alloy (AZ31V) almost showed two orders of magnitude lower values in comparison with that of the AZ31 Mg alloy, and the corrosion potential of AZ31V Mg alloy increased from −1.41 to −1.25 V. The immersion tests proved that there was no occurrence of severe corrosion. Hence, the alkali pretreatment and vanillic acid treatment may represent a promising method to improve the corrosion resistance of Mg alloy.     

水泥厂余热发电对系统短路电流的影响 及限制措施

某些旧水泥厂设计时未考虑短路电流余量,余热发电与水泥线总降压站系统并网运行后,最大短路电流会超过断路器的遮断容量,会对水泥厂原有电力系统造成损害。为了保证系统的安全运行需采取相应的限流措施保证电力设备安全,以伊拉克MASS集团25 MW余热发电改造项目为例,说明采用限流电抗器,采用快速限流装置和改变接线方式这三种不同限流方案的应用结果。     

In situ polymerization of flame retardant modification polyamide 6,6 with 2-carboxy ethyl (phenyl) phosphinic acid

A novel halogen-free flame retardant copolyamide 6,6 (FR-PA66) was prepared successfully by in situ polymerizing with adipic acid hexamethylene salt and 2-carboxy ethyl (phenyl) phosphinic acid (CEPPA). The elemental composition and chemical structure of FR-PA66 were characterized by energy dispersive X-ray spectroscopy, Fourier transform infrared spectrometer and ¹³C Nuclear magnetic resonance spectrometer. The flame retardancy, thermal stability, and morphology of char residues were also investigated by the limiting oxygen index (LOI), UL 94 test, thermogravimetric analysis, and scanning electron microscopy. The results showed that FR-PA66 samples had much better flame retardancy and char formation ability than pure PA66 after the flame retardant modification. The LOI values were increased from 24.0 to 28.0% by adding 6 wt % of CEPPA and all FR-PA66 samples were rated as V-0 rating in UL-94 test. Furthermore, the thermal stability analysis indicated that in situ polymerization with CEPPA effectively decreased the initial decomposition temperature and increased the amount of char residue. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019 , 137, 48687.     

加快能源工业用钢开发支撑国家能源战略实施——武钢发展战略的思考

能源给人类带来光明,能源给社会进步提供了动力,尤其是进入21世纪以来,能源的可持续发展己成为直接影响世界经济社会可持续发展的决定性因素之一。中国政府高瞻远瞩地提出到2020年要实现国民经济翻两番和建设节约型社会的目标,描绘了支撑这一发展目标的十分宏伟的能源发展战略,使人振奋,也对我国钢铁产业的发展提出了更高的要求,作为长期以来与我国     

渣油胶质和沥青质在分散型催化剂作用下的临氢热反应行为

采用四组分法从辽河减压渣油中分离出胶质、沥青质，分别考察了它们在分散型催化剂作用下的临氢热反应行为。结果表明，胶质、沥青质一方面要裂化生成较轻的产物；另一方面也要发生缩合反应生成较重的反应产物以及甲苯不溶物。渣油在临氢热反应过程中，沥青质是生焦的主要来源，其次才是胶质。比较了热反应生成的沥青质与原生沥青质之间以及热反应生成的胶质与原生胶质之间化学组成的区别，结果表明，反应生成的沥青质和胶质较原生的沥青质和胶质分子结构缩合程度高，并且反应苛刻度越高，缩合程度也越高。